Solution for the semi-trailer electrophoresis paint.
Product Introduction
HLS-5702LB/HLS-5780 Gray Cationic Epoxy Electrocoat for auto is the
7th generation electrophoretic coating researched and developed by
HLS Paint (Shanghai) Co., Ltd. in cooperation with Germany HS
International Chemical Industry Group. It represents modern
technology of cathodic electrophoretic coating that is
environment-friendly with high property and low cost. Such coating
does not contain heavy metal like lead, tin, cadmium and mercury
etc. It is a two-component, water-dispersed resin,meanwhile, it
took in features of previous products, and can adapt galvanized
steel sheet perfectly, almost can be applied to foundation coating
of all metal, such as: cold and hot rolled steel sheet, galvanized
steel sheet, aluminum products, zinc-aluminum alloy sheet and
stainless steel sheet etc
This product features shown below:
| Good stability of bath can adaptable for a longer updating cycle. |
| The appearance of the coating is flat, delicate, smooth. |
| The bath has strong anti-shrinkage and anti-pollution ability. |
Main ingredients
1.Matrix resin: Acrylic modified epoxy resin
2.Solvent: alcohol ether
3.Pigment: carbon black, kaolin, antirust pigment
Product quality data
| Project | Technical data | Test standard |
| Resin (HLS-5702LB) | Gray Paste(HLS-5780) |
| Appearance | —— | Milky white liquid | Gray viscous liquid,no agglomeration | Visual |
| pH | 25℃ | 6.0±1.0 | —— | GB/T 9724 |
| Conductivity | 25℃, μs/cm | 1100±400 | —— | HG/T 3334 |
| Storage stability |
No stratified state, and there were no obvious difference compared
to before storage | In 5-35 ℃ temperature 1 year |
Note: pH, conductivity measurement in the resin/pure water = 1:1
dilution
Storage, packaging and transportation
This product is a water-borne industrial coatings, non-hazardous,
non-inflammable and explosive products; transportation to prevent
direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L
Plastic barrel; in the transport and storage of drums should be
maintained clean, avoid charging the dirt brought in on drums
during filling tank, again checked and confirmed that the quality
of products, including paste resin, emulsions and additives should
be indoor storage, good ventilation, dry, protect against freezing
and overheating, the storage temperature should be controlled at
5～35℃, products from the date of production, over shelf,
experimentation is required to determine whether can continue to
use.
